1.Have powerful adhesive and good durability.

2. Quick-fixed（10 seconds）

3. 20 mins can reach good initial bonding strength, 12 hours can meet the adhesion requirements on the use intensity. 72 hours can reach best adhesive strength.

4.High bonding strength, large bearing capacity.

5.Have excellent adhesive and good durability between -15℃~+70℃.

6. Moisture-proof, worm proof, anti-crack, mildew proof, non-deforming. No formaldehyde and benzene, no poison and radiation, little odors. Comply with the limit of harmful substances of adhesives environmental standards of GB 18583－2008

7. In certain conditions has sufficient flexibility to allow some board shrinkage or movement,can be repeated bonds within 20min.

1.Surfaces must be clean and free of impurities, to ensure the materials are fully bonded。

2. Materials must to be tested before bonding, widely use after achieve the satisfy result.

3.Cut the top of cartridge, pierce the inner aluminum film from the top. According to the material area of bonding to cut the injection nozzles slantly for 6mm to 9mm diameter hole, put the injection nozzles on the top of cartridge, and place in cartridge gun.

4. Apply the adhesive to one of the surfaces in either a continuous or spot bead, press surfaces firmly together with a slight twisting motion,  until adhesive dried.

5. Large applications may require applying the adhesive to both of the surfaces , Apply even. After 10-20seconds, press surfaces firmly together,and may require additional bracing until adhesive has dried.

1. Highly corrosivity, not fit for foam, copper, etc. which easy to be corrupted material, For easy to be corrupted material , We recommend HENDER 470 liquid nail (Noncorrosive Adhesive).

2.Not for unventilated spaces ; not suitable for continuous immersion place; when material surface temperature higher than 40 ℃ or below minus 5 ℃, not for construction.

USE INSTRUCTIONS : 

1.Surfaces must be clean and free of impurities, to ensure the materials are fully bonded。

2. Materials must to be tested before bonding, widely use after achieve the satisfy result.

3.Cut the top of cartridge, pierce the inner aluminum film from the top. According to the material area of bonding to cut the injection nozzles slantly for 6mm to 9mm diameter hole, put the injection nozzles on the top of cartridge, and place in cartridge gun.

4. Apply the adhesive to one of the surfaces in either a continuous or spot bead, press surfaces firmly together with a slight twisting motion,  until adhesive dried.

To keep the construction site ventilation, avoid inhalation of volatile gas in curing process, stored out of reach of children; if accidental eye contact with the uncured adhesive, should be promptly wash with plenty of water and consult a doctor.